Vintage Gruen
The forum for Gruen watch enthusiasts

Home » General Talk, Buying and Selling » Open Discussions » Lathe Junkie
Lathe Junkie [message #7840] Thu, 23 February 2017 20:32 Go to next message
GaryM is currently offline  GaryM
Messages: 1164
Registered: May 2013
Location: Seattle
Gruen Authority
Cheerleader

Last day of winter clock class and one of the previous instructors brought in a 6mm lathe setup that I was interested in seeing. Be careful in what you ask for...

index.php?t=getfile&id=3231&private=0

A 6mm long bed dual head Lorch & Schmidt setup. In the box a somewhat complete Lorch & Schmidt 6mm set. 1 6mm short bed, the head can be offset for cutting tapers and such. The other newer short bed has an 8mm head, bonus! Some extra odd size 6mm wax collets and various odd size 6mm collects were in the box. Some extra face plates and a cheap 6mm 3-jaw chuck.

Finally large dovetail table was thrown in for good measure, heavy! Probably used for precision drilling.

I'm now a junkie for sure. This will keep me entertained for quite a long time. Very Happy
Re: Lathe Junkie [message #7844 is a reply to message #7840] Sat, 25 February 2017 03:52 Go to previous message
JackW is currently offline  JackW
Messages: 1225
Registered: May 2013
Location: Denver
Gruen Authority
General pain in the rear
Site Admin
nice!

All I know is based on hard work & writing by others. I can only aspire to augment this body of knowledge. If I am wrong it is because of my own failings. -me

"If I have seen farther it is by standing on the shoulders of giants." - Newton
Previous Topic: Gruen Metal signs
Next Topic: Watch Storage
Goto Forum:
  


Current Time: Fri Jan 19 03:42:45 UTC 2018

Total time taken to generate the page: 0.00754 seconds