Vintage Gruen
The forum for Gruen watch enthusiasts

Home » General Talk, Buying and Selling » Open Discussions » Ultrasonic Liquid (What type ?)
Ultrasonic Liquid [message #5598] Thu, 04 June 2015 15:45 Go to next message
MonKee is currently offline  MonKee
Messages: 145
Registered: May 2013
Location: Finger Lakes
Gruen Guildsman
I was reading on another forum that a fellow uses Isopropyl Alcohol as his liquid to do Ultrasonic cleaning. i thought that sounds unusual. So a question for those that use an Ultrasonic Cleaner, what liquid do you use and why ?
Re: Ultrasonic Liquid [message #5602 is a reply to message #5598] Thu, 04 June 2015 19:46 Go to previous messageGo to next message
MikeTheWatchGuy
Messages: 351
Registered: May 2013
Location: North Carolina
Gruen Guildsman

I use a variety of chemicals depending on the task at hand. To clean cases that I've polished that have that horrible black grime left on them I use ammonia.

I use alcohol sometimes when I'm removing rust from parts. It's the last step and is done to remove water that may be on the parts from the previous steps.

For movements, etc, it's the standard issue L&R cleaner and rinse.
Re: Ultrasonic Liquid [message #5610 is a reply to message #5602] Sun, 07 June 2015 00:20 Go to previous messageGo to next message
JackW is currently offline  JackW
Messages: 1225
Registered: May 2013
Location: Denver
Gruen Authority
General pain in the rear
Site Admin
I use commercial "Oakite" for cleaning metal parts. For watch parts, I use the L&R stuff as Mike indicates.

All I know is based on hard work & writing by others. I can only aspire to augment this body of knowledge. If I am wrong it is because of my own failings. -me

"If I have seen farther it is by standing on the shoulders of giants." - Newton
Re: Ultrasonic Liquid [message #5615 is a reply to message #5610] Sun, 07 June 2015 14:45 Go to previous messageGo to next message
Thojil is currently offline  Thojil
Messages: 618
Registered: May 2013
Location: Silver Lakes, South Afric...
Gruen Master
I'm using ELMA products available in Europe.

Stage #1 I use ELMA Cleaning Solution 1:9 and in stage #2 ELMA Suprol which also removes any remaining moist.
Re: Ultrasonic Liquid [message #5908 is a reply to message #5615] Thu, 03 September 2015 02:15 Go to previous message
Timeticker is currently offline  Timeticker
Messages: 486
Registered: June 2013
Location: Somewhere in the world
Gruen Guildsman
I use a home made formula that shines brass like new. For the Ultrasonic, I use "Magic Green" by Grobet USA. Also, I have used bleach on porcelain dials, and other common chemicals around the house. I am always looking for something new, and for the most part, have had great results. I am not equipped to shine cases, so I send them out for professional finishing.

People you thought were your best friends will stab you in the back to your face!

Love them anyway.
A "Paradoxical Commandment"
Previous Topic: Jack ??
Next Topic: Happy Birthday Vintage Gruen!
Goto Forum:
  


Current Time: Thu Jan 18 01:57:06 UTC 2018

Total time taken to generate the page: 0.02704 seconds