Vintage Gruen
The forum for Gruen watch enthusiasts

Home » General Talk, Buying and Selling » Vendor Area » Watch case replating
Re: Watch case replating [message #3681 is a reply to message #3577] Sun, 11 May 2014 12:35 Go to previous message
slinfiniti is currently offline  slinfiniti
Messages: 20
Registered: May 2013
Location: Raleigh NC
Gruen Apprentice
I have used then for several of my watches. The silver colored watches they did an amazing job. I sent an old trench watch case with wire lugs that the plating had all been worn off. The did a beautiful job of refinishing it. The yellow finish was a bit to orange for me, not what you might call a Hamilton" yellow. But, beautifully done, even patina and after one year, no issues!

I also sent a Quadron to have the case lugs redone, new finish and plating. Wonderful job on the lugs, the spring bar holes were repaired nicely, a pin size case hole filled in and the plating. It cost me $85.00, but the watch looks new!

I will use then again
Read Message
Read Message
Read Message
Previous Topic: Gruen's booklist
Next Topic: A couple of reference sites for staffs & winding stems
Goto Forum:

Current Time: Sun Mar 18 05:54:37 UTC 2018

Total time taken to generate the page: 0.00783 seconds