Vintage Gruen
The forum for Gruen watch enthusiasts.

Home » The Gruen Model Database » The caliber database » Caliber 849 - 6.5L, 16J - Factory L (6.5'" 16J)
Re: Caliber 861 [message #11815 is a reply to message #11804] Thu, 05 December 2019 20:56 Go to previous messageGo to previous message
Case is currently offline  Case
Messages: 1178
Registered: May 2019
Location: Cincinnati
Gruen Authority
Thanks, Gary & Liz--I knew I'd seen this gorgeous watch earlier, but if I search any numbers on the forum it returns no results. Frustrating! Good to have confirmation it's Factory L. Then again... *sigh*

So my dates for mine were right, pre-1920.

I'd looked at the setting bits for both. Super close, but there seems to be a sight difference between 849 & mine/Liz's. Note the notch on the large piece: ours is more triangular vs. the 849. Note also the opposite end of that piece: there's a slight difference (849 not the same on top & bottom, different taper on the tip). I took that this was a 861, since both ends matched better. I could not find a pic of the actual movement, nor did I make out one below. Did I miss it?

Either way, these two must have been nigh identical: same size, almost same setting bits. Likely both from Factory L.


/vgforum/index.php?t=getfile&id=5721&private=0


My two caveats:
1) I'm wrong many times a day --just ask my wife!
2) Always seeking to learn more
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: The Caliber 250 Dietrich Gruen
Next Topic: The Caliber UltraThin
Goto Forum:
  


Current Time: Mon Nov 25 02:47:57 UTC 2024

Total time taken to generate the page: 0.01163 seconds