Vintage Gruen
The forum for Gruen watch enthusiasts.
Home » The Gruen Model Database » 1920's » Strap 17 (826ss green gold)
Re: Strap 17 [message #13669 is a reply to message #13665] Fri, 04 September 2020 00:18 Go to previous messageGo to previous message
thesnark17 is currently offline  thesnark17
Messages: 654
Registered: January 2017
Gruen Master
I bought this watch in pieces, and the pieces were bent. The back cover was warped and the bezel had some complex bends in it. I felt sorry for the watch; what can I say. I knew it would be scrapped if I didn't intervene.

I spent a lot of time straightening out the bezel and case back, and now they snap on and off quite nicely. The fit could still have been better (or so I thought at the time), but I eventually decided that discretion was the better part of valour. So I put the watch in a drawer and forgot about it...

It needs a crystal, case screws, and a sweep-seconds support spring to be whole again. At the moment, it only runs for a minute at a time before the sweep seconds assembly becomes misaligned.

Looking back at it now, I'm quite proud of how well the case repair went. I would never have thought it was bent at all! I should have taken some "before" pictures.

Report message to a moderator

[Message index]
 
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Read Message
Previous Topic: Strap 62
Next Topic: Unknown Wristlet with enamel
Goto Forum:
  

[ Syndicate this forum (XML) ] [ RSS ] [ PDF ]

Current Time: Fri Jan 30 21:30:16 UTC 2026

Total time taken to generate the page: 0.02547 seconds
.:: Contact :: Home ::.

Powered by: FUDforum 3.1.3.
Copyright ©2001-2023 FUDforum Bulletin Board Software