| Re: The Caliber UltraThin [message #16545 is a reply to message #16544] |
Sun, 01 May 2022 00:07  |
 |
JackW
Messages: 1998
Registered: May 2013
Location: Denver
|
Gruen Authority
Head Janitor
Site Admin |
|
|
thesnark17 wrote on Sat, 30 April 2022 14:13True, that.
Unfortunately, with the thickness of the movement plates, it may be impossible to repair the threads if they are bad. I assume that they were stripped, necessitating the epoxy; I suppose it's possible that it's the wrong screw and too small for the hole but it seems unlikely.
I'd kindly disagree, that it is impossible. Just freaking difficult. Like doing a helicoil on an engine block. Except smaller. Granted, this is arm-chair quarterbacking at its finest.
All I know is based on hard work & writing by others. I can only aspire to augment this body of knowledge. If I am wrong it is because of my own failings. -me
"If I have seen farther it is by standing on the shoulders of giants." - Newton
|
|
|
|
Vintage Gruen
Blog
Pages
Search
Help
Members
Register
Login
Home
